Contact for further information
Please contact BlueCats if you wish to purchase this module – it ships without firmware therefore further setup/configuration will be required.
Alternatively, fill in the contact form and we will get in touch shortly.
Based on the ultra-low power CC2640 wireless MCU from Texas Instruments. The BC010 can be connected directly to a battery or SMT soldered to a host PCB and is ideal for data logging from BlueCats Sensor Boards while the rest of the system is in sleep mode. The module is perfect for application where battery life, small form factor, RF performance and speed to market are important.
|Dimensions||19.4 x 14.9 mm (0.76 x 0.59 in)|
|Power Source||Powered by host PCB (otherwise CP224147 3V 800mAh can be welded directly to pads)|
|Recommended Operating Temeprature||-40°C to +85°C|
|Bluetooth Specification||Bluetooth 4.2+|
|Supply Voltage||2.3 - 3.8 V DC|
|Tx Power||+0 dBm @ 6.1 mA|
|Tx Power||+5 dBm @ 9.1 mA|
|Rx Sensitivity||-97 dBm|
|Range||400 m (+5 dBm tx power, 153 ms ad interval, 3 channels, iPhone 6, slow presence detection)|
|Certifications||Pending Bluetooth qualification|
|FCC/IC modular certification|
|Australia / New Zealand compliant|
|13 remappable GPIO|
|UART, 2x SPI, I2C,I2S|
|4 mBit External Flash (SPI) - 1 temperature measurement (5 bytes) per minute for 53 days|
|Reverse polarity protection and power filtering/decoupling built-in|
|No external components required||SMT solder module to host PCB|
|or connect battery directly to module (no host PCB)|